- Mon Sep 21, 2020 4:59 pm
#45476
Hi,
12v supply is stable and in battery voltage ADC pin is about 2.5v.
in debug is supply in volts?
software is unmodified BL49sp as is schematics,
only used nanolambda kicad file as a base beacuse cj125 was ready there.
What i understand is only things needed to move on from preset is that supply voltage is in allowed range and cj125 responds that all okay. and in debug there should be cj125 hex code, that tells what its state is, but it reads only 0, so could it be that cj125 is somehow not responding at all?
12v supply is stable and in battery voltage ADC pin is about 2.5v.
in debug is supply in volts?
software is unmodified BL49sp as is schematics,
only used nanolambda kicad file as a base beacuse cj125 was ready there.
What i understand is only things needed to move on from preset is that supply voltage is in allowed range and cj125 responds that all okay. and in debug there should be cj125 hex code, that tells what its state is, but it reads only 0, so could it be that cj125 is somehow not responding at all?