I am using wasted spark mode, not sequential. So according to BOM, this is not necessary.Vauhtivaunu wrote:Also you should solder IC3 and all mosfets (Q1-Q10) in place.
To be safe I uploaded the 202005 version to the board (attached the tune down below), but the problem still occurs.
I just tested this and unfortunately, they don't. I am starting to think I fried something.pazi88 wrote:Do the injector leds work in HW test mode?
What exactly do you mean by this? If it displays correct reading of the battery voltage? If so, I have not tested this.pazi88 wrote:Also does the TS so correct voltage readings?
(60.59 KiB) Downloaded 30 times