- Fri Sep 18, 2020 2:32 am
#45413
Alright I changed it to rising edge and to my surprise car started and ran fine lol. I didn't need to change timing or anything. I dropped the spark table 20% just to be safe though.
Went for a pull and still getting sync loss.
Also got a tooth log and realized that wires were switched because of the double long bars so switched the wires but didn't solder yet. It fixed the double bars to a single tall one. I wonder if not soldering could have cause the sync loss now. I will solder just to take it out of the way though.
I am attaching a pic of the tooth log and the two pulls I did but I will attach the logs also
All the attachments and pictures are with the rising edge
Went for a pull and still getting sync loss.
Also got a tooth log and realized that wires were switched because of the double long bars so switched the wires but didn't solder yet. It fixed the double bars to a single tall one. I wonder if not soldering could have cause the sync loss now. I will solder just to take it out of the way though.
I am attaching a pic of the tooth log and the two pulls I did but I will attach the logs also
All the attachments and pictures are with the rising edge
Attachments
(80.44 KiB) Downloaded 233 times
(6.04 KiB) Downloaded 226 times
IMG_20200917_192404.jpg (5.2 MiB) Viewed 3128 times
IMG_20200917_192422.jpg (5.22 MiB) Viewed 3128 times
IMG_20200917_192539.jpg (5.33 MiB) Viewed 3128 times