Help with building your Speeduino, installing it, getting it to run etc.
By Slydit
#44552
just cranked the 1600 mx5 for the first time. no2c board batch fire with (360cc?) injectors...
ive downloaded the 202005 firmware and base tune but its idling at 11:1 at 8% VE and i cant get it any leaner. if i go 7% the engine stalls out... im running 2 squirts per cycle wasted spark....
any ideas why i cant get it any leaner?
the injectors are mazda gtx injectors and ive seen flow numbers from 330cc to 430cc so who knows.) cant find any dead time numbers for them either so just used 1.0...
maybe go to 1 squirt [er cycle??

also my idle valve doesnt appear to work... is there any way to test it/ ramp it up to try and get it to move the rpm manually?
oh also the base map didnt have any injector close timing at all so i put in 350 accross the rpm range? i sthat correct?
By LPG2CV
#44553
Halve the required fuel, and double the ve. One is just a multiplier of the other. So your ve for that cell, would become 16. then you can reduce in smaller amounts. :)

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?