- Wed Jul 15, 2020 2:31 am
#44246
then looks like you have some short circuit between 5v and ground. check your soldering and see any soldering bridges between the pads.
Raku wrote: ↑Tue Sep 01, 2020 2:49 am q1 is coil driver.make sure you have base tune loaded up before plugging in to the car. and make sure spark output trigger is set to going low.That fixed my issue, it was configured to going high. I was able to crank the car over after changing that setting. A new issue I have is it doesn't seem to read my wideband sensor, I have it plugged in to the pin on the board marked as o2. I checked voltage at this pin from my o2 sensor and everything looks correct. Do you know how I can troubleshoot this?
Always going to be one, I have completed 3 convers[…]
Do i have to do something in arduino software ? i […]
Hola a todos Actualizo!!! Me es grato comunicaros[…]
Still can't find what you're looking for?