Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any questions you have before you begin buying, building and installing.
By master_pgl
#44236
Hi
I need again some help.
I would like to connect the cam senso via VR conditioner, but I have no idea if its a hall or iductive sensor.
The Type is Bosch 0232 103 022 with 3 pins. It is magnetic so it could be inductive, but all inductive sensors I know are connected by 2 pins.
I measured also the resistance between all pins, its huge ->infinite. This would mean its a hall.
By master_pgl
#44241
I found detailed informations. It is a hall sensor.
The pins are:
1: GND
2: Signal
3: power supply

By the way, it is the crank sensor in my case not cam as written above.
By master_pgl
#44272
Now there is an other stupid problem.

I connected 5V as power supply to this sensor, the output should be 5V squere, but it is 0,5V (the cable has no any divider)

Image


The other thig is, the wheel has 2 missig theets, but the gap looks much longer.

Any ideas what could it be?
By master_pgl
#44299
One problem solved. The reason for missing pulses was the position of my sensor, I reduced the gap between wheel an sensor and it seams to be ok.

I checked this with an other sensor, same type (just a second one), the behaviour is exactly the same, 0,5V output, even with 12V supply.
My Idea is to use the VR-Conditioner, but I am not sure how to connect.
Is this so possible?
Image
By dazq
#44304
I don't think you need the vr circuit tbh.
It would appear to be a lack of suitable pull up that is causing your voltage issues, do you have any fitted?
By master_pgl
#44333
You are right, i didnt connect the pullup resistor. Sometimes the solution is durectly in front of your eyes and you dont see it :lol:

Perhaps post your tune. And a log of it cranking/r[…]

Hi JHolland Thanks for the comment. This gives me[…]

Sync loss on gsxr

I see you did find the DC settings on your scope :[…]

540HP NA 7L V12 3Seater

Thanks for the suggestion, I had not considered th[…]

Still can't find what you're looking for?