Firmware live stream happening this weekend: viewtopic.php?f=13&p=43195
Help with building your Speeduino, installing it, getting it to run etc.
By Luke J
#41828
Hi everyone, I'm building a bench test kit for my uni project similar to the one in this link https://youtu.be/k6gEccn17Ro. Everything is good so far but I'm at the stage where he plugs in the ignition led light to ground an ignition channel to check the timing of the ignition. However, the led doesn't flash when connected. The ignition leds on the board flash as expected. I'm using a 5v led from rs components.
Board is 0.4.3
4 stroke engine
By Luke J
#41829
Forgot to add that the speedy is only powered by the USB from my laptop, do I need to add the power for the arduino plug or the 12v directly on the speeduino to make it work?
NA VVT Swap No Start

Relevant manual page: https://wiki.speeduino.com[…]

E190 2.3 8V FUEL ONLY

I think there is a reason why OEM bosch costs 70$ […]

May 2020 firmware release

I could try the 680 ohm, but the onboard pullup […]

past my bedtime! I'll watch it on catchup.

Still can't find what you're looking for?