Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
By bugster_de
#39762
Hi,

I'm working on my own Speeduino board design at the moment (slow progress a long the lines of spare time unfortunately) and I seem to be unable to source the surge protection Varistor in the 5V Powersupply over here in Germany.

The component in question is ERZV14D220.

Can anyone recommend an alternative / replacement for this which would be easier to source?

Thank you so much
By dazq
#39765
Does this mouser part not appear on the German site?

https://www.mouser.co.uk/ProductDetail/ ... oswqDhA%3D
Last edited by dazq on Tue Dec 10, 2019 2:35 pm, edited 1 time in total.
By pazi88
#39766
Any surge varistor with same specs or close enough is same. In mouser/digikey, you can tick the specs of the component and use "show similar" for that.
By dazq
#39768
Sorry pasted wrong link ,changed to correct one now these show delivery expected 16dec, 960 on order
By bugster_de
#39950
Hi folks,

thanks for the reply and hints.
The component shows up on mouser.de but they expect minimum order volume. So I will need to collect my complete BOM and then order with them.

Best regards
STM32 development

Thanks for the reply. I am aware of the settings i[…]

The firmware appears to allow you to choose 2 cy[…]

Great to see this post have been ressurected, i ha[…]

2 per cycle is what you need. If you are runnin[…]

Still can't find what you're looking for?