[PSIG]

The PCB should not need MAP sensor notching for clearance if mounted in the correct way. On the Speeduino v0.3/0.4 boards they are mounted upside-down (hole up instead of properly hole down and writing up). In your images, the sensor is shown mounted either upside-down on top, or properly but on the bottom of the board. I would mount it away from the edge like pazi88 shows, but correctly oriented and with no notch. But that's me. Do your thing.

David

[Raku]

Ah I can do that too. I do like to put the map sensor completely inside the casing so I'll be protected if dropped or something happens. I designed this based on 0.4.3 design and haven't looked at 0.4.4 design so that's the problem

[Raku]

updated the pcb to rev 1.4 with map sensor orientation + proto area with 2 analog and 2 digital pins.
hopefully this will be the last revision

[MatijaCHA]

I trayed to buy the exported BOM at LCSC do i need to buy allso the v0.3/v0.4 Component kit from the Speeduino site..?

[Raku]

no bom has all the components

[MatijaCHA]

OK so i need to buy only The MAP sensor and the Arduino Mega 2560 separate ..?

[pazi88]

OK so i need to buy only The MAP sensor and the Arduino Mega 2560 separate ..?

Map sensor is also included in his bom. Only arduino mega isn't.

[Raku]

and you need a vr conditioner if you using stock crank sensor. speeduino vr conditioner will work.

[MatijaCHA]

yeah i noticed at number 39 the MPX4250AP... The problem is the auto BOM pull from the LCSC website it renumbers all and dont pronounce what is missing what they dont have. It only shows 33 items from 47 i will have to analyse what is missing and then buy it separate form other dealers... any other links mybe where to paste the BOM and buy..? or i will do it the long way...

[Raku]

Unfortunately lcsc doesn't have all the components. You need to find other sources to buy some of the components that lcsc doesn't have.