For discussion of anything related to the Speeduino documentation wiki
User avatar
By gökhan.demirci
#14879
Hello
i tried to get rpm signal on dist. but nothing got it.It is 3 cable hall sensor.i tried connect signal directly arduino board but nothing got it.
I think i make a mistake on somewhere but dont know.Car is audi 80 2.0 16V same as other vw hall effect distribütör.
Anybody can figure wiring ?
User avatar
By PSIG
#14885
Can you post the engine wiring diagram for your engine?

David
User avatar
By gökhan.demirci
#14893
Jumper settings are jp2 halll,jp4 on other open.
I test it with power suply it is 12v.cant figure car wiring diagram.
I tried all 3 wire as signal change polarity.my boards some components not installed but everything is ok about ignition input.just sp721 and ignition out components missing.
By klotzy_550
#14894
gökhan.demirci wrote:Jumper settings are jp2 halll,jp4 on other open.
I test it with power suply it is 12v.cant figure car wiring diagram.
I tried all 3 wire as signal change polarity.my boards some components not installed but everything is ok about ignition input.just sp721 and ignition out components missing.
If the Hall sensor is 12V it will kill the Arduino input, needs to be 5v or less.
By androidcho
#14895
If the Hall is 12V, you can use the 10K pullup jumper if it's active low, the resistor acts like a divider.
By Trequal
#14900
It is me sorry for multi account for facebook.
Today i measure multimeter with hall sensor.signal and ground short circuit akk the way.nothing change with turning distributer.i know hall sensor works like seed relay am i wrong?
Honda J30 running

Okay, we now need to talk about violence and backg[…]

Vr Conditioner Noise when cranking

I checked and my sensor is not loose. Trigger whee[…]

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Still can't find what you're looking for?