- Tue Jul 19, 2016 12:46 am #10729
I suppose the other way to look at it, is that ignition timing control should not be worse than it was as-stock (accuracy), but will be better for it's ability to run whatever timing the engine needs for best efficiency, power and torque with tuning. So, if it gets you going for now you could run the VR wires into a GM module to condition the VR signal, and trigger the module output with Speeduino. Same basic setup MS would use with a GM 7 or 8-pin. I am hoping to set-up a lot of distributor-triggered ignitions with only one pulse-per cylinder in classic car conversions; so it has to control timing at least as well as stock in Basic Distributor mode.
-= If it was easy, everyone would do it =-