Jansun wrote:the "S" and a portion of the "P" will be lost if this logo is done in blackl and white. Perhaps try lowering the entire speeduino text to the lower right portion of the logo, away from the infinity circles kinda like you did in your sketch.
cx500tc wrote:exactly, the autozone logo kinda looks like the text and the dash are speeding off in opposite directionscygnus x-1 wrote: Like this? (Except not for Autozone)Sort of...
C|
Just thin to thick, not thick to thin as that goes.
evo_lucian wrote:Good point. If there is any interest in the logo i will.Jansun wrote: the "S" and a portion of the "P" will be lost if this logo is done in blackl and white. Perhaps try lowering the entire speeduino text to the lower right portion of the logo, away from the infinity circles kinda like you did in your sketch.
Old Grey wrote:The one above needs that stretched out text like cx500's one, and maybe the open source logo is too dominating.Wondering.....
Throwing out another idea.
evo_lucian wrote:Shrink, vertically, "SPEEDUINO" down to fit under the Arduino / infinity. Maybe even slide that over to the left as far as possible.Jansun wrote:the "S" and a portion of the "P" will be lost if this logo is done in blackl and white. Perhaps try lowering the entire speeduino text to the lower right portion of the logo, away from the infinity circles kinda like you did in your sketch.
Had it running for a short period again. Same as […]
Ok, here is the first version of the adapter plate[…]
Yes, totally wrong setting. Slight noise in TPS ca[…]
Still can't find what you're looking for?