I have a compeltely bonkers idea need some help.
I have megasquirt 2 v3 but honestly think that open source is 100% the way to go. [I need semi sequential for siamese engines - do not believe speeduino is there yet.]
Looking for guidance,
I would like to take speeduino code, someone guide me what to strip out the code that operates the engine, replace/populate engine data using mantonakakis1's https://github.com/mantonakakis1/MegaCAN code to pull all the megasquirt engine data in to my arduino(or possibly intel with mini pcie can card)/speeduino along with my own GPIO pins (eg 5 stepper drivers, heater,ntc thermistors and end stops.
I am planning to control intake manifold runners, electronic egr, rtc controlled oil pre-heater, radiator shutters and few other things.
Using the speeduino front endy part sort of thing (where I need developers help) connected to tuner studio to display a dash via the arduino's serial port because megasquirt is closed source and ms3 is limited and anything a little bit extra results in a statement closed source protocol & licenses and all that gory mess.