Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For general talk about the Speeduino project itself. Future plans, legal stuff, meta etc.
By Bruceynz
#42580
Hi Everyone,

I am in the process of building up a 6.1 Hemi and I want to speeduino it! I need to get this crank trigger wheel sorted before I bolt it together.

I am unsure if the factory 6.1 crank trigger wheel will work, it has missing teeth plus a section with no teeth.

Here is a photo of one here https://i83.photobucket.com/albums/j312 ... M_0541.jpg

Thanks
Bruce
User avatar
By PSIG
#42588
Almost. You need to request a 36-2-2 decoder. It should be a fairly simple mod to existing decoders, so post your request on the decoders thread and perhaps on Slack for one of the code wizards to see.

Speeduino only reads one edge on each tooth, ether rising or falling. It does not care if the teeth are filled or cut-out, they are still just missing teeth for a duration between the selected rising or falling signals. If you look at your wheel below, you can see an example of using falling-edge detection (green and orange lines), and that Speeduino will see the same duration from one falling edge to the next, on both sides of the wheel. That makes it a basic and symmetrical 36-2-2 trigger wheel.

You can perhaps see that if rising-edge were used, the results would be the same, but Trigger Angle would be shifted CCW by (360/36)/2=5°. The black lines were only to verify how far out-of-square (distorted) the image was. Hope that helps.

David
MOPAR_36-2-2.png
MOPAR_36-2-2.png (265.04 KiB) Viewed 1924 times
By Bruceynz
#42595
Hi David,

Sorry for the dumb question but where is the decoders forum, I had a look and search but no luck.

Thanks
Bruce
turbo timer function?

Indeed you can easily add a $5 timer relay on the […]

It seem like no one is using it yet. So you should[…]

Yeah I think it needs one squirt at 0 and the othe[…]

@ MegaTun, Sorry for the late reply. For private r[…]

Still can't find what you're looking for?