Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For general talk about the Speeduino project itself. Future plans, legal stuff, meta etc.
By hawlok
#32627
Welcome, forgive if there is something rare, i translate with google translator, i try to make a model that have injectors, cop coils, fuel pump, vacuum pump for the air collector and fan, the lambda probe will be a potentiometer at the same time as other sensors , the intention is that with the help of everybody can explain the functioning of speeduino and that anyone can make a model as this with what we will explain here. we start!, i have thought connecting the 12v gas pump to the proto area, correct me if i am wrong, i have to weld a darlington uln2803 transistor so that entry 45 exits by pin 16 which goes to a 5v relay with which control the pump, is this correct? thank you.
User avatar
By PSIG
#32634
@hawlok - which PCB version are you using? An example to reassign the output to an unused high-current output is here: https://speeduino.com/forum/viewtopic.p ... 569#p23096

If you do not have an unused HC output, then you can use a ULN2803A type of chip to power the FP relay from the proto area. An example of installing and using the chip on a v0.4.1+ series PCB is here: https://speeduino.com/forum/viewtopic.p ... 588#p16588

David

So I had a chance to take another look at my timi[…]

Sync loss on gsxr

I see you did find the DC settings on your scope :[…]

540HP NA 7L V12 3Seater

Thanks for the suggestion, I had not considered th[…]

Decoders - What do you want to see?

Please at least download TS and load the base tune[…]

Still can't find what you're looking for?