For anything not related to Speeduino, but still about car/bike/boat/engines etc
#45339
so in brief, i'm building a kit car, its using a 2.5l v6 ford duratec engine with turbo and all the goodies to get that to do what it does, this is being mounted mid engine rwd, obviously im running a speeduino ecu with this and an onboard raspberry pi4 for tunerstudio and pi-dash, but i need some advice as to how to get a speedometer working, the gearbox has a plug where i would have expected to see the old whirly type speedo cable, is it a case of supplying 5v and ground and then connecting the output wire to an i/o pin in the pi?

(admins) not sure this is the correct place to ask on the forum so please feel free to relocate.

thanks in advance for any help
#45630
Out of interest, what gearbox are you using with your engine?

I think possible reasons for that would be: 1) loo[…]

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?