Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything not related to Speeduino, but still about car/bike/boat/engines etc
#45339
so in brief, i'm building a kit car, its using a 2.5l v6 ford duratec engine with turbo and all the goodies to get that to do what it does, this is being mounted mid engine rwd, obviously im running a speeduino ecu with this and an onboard raspberry pi4 for tunerstudio and pi-dash, but i need some advice as to how to get a speedometer working, the gearbox has a plug where i would have expected to see the old whirly type speedo cable, is it a case of supplying 5v and ground and then connecting the output wire to an i/o pin in the pi?

(admins) not sure this is the correct place to ask on the forum so please feel free to relocate.

thanks in advance for any help
#45630
Out of interest, what gearbox are you using with your engine?
No synchronize

Maybe your VR conditioner has failed on one channe[…]

LED's 5,6,7,8 on all the time

Yeah, grounded Ardu-Stim to pin 10 on the 40 way I[…]

2CV 602 flat twin

Is it the 123 with the MAP feature? What engine ma[…]

PCB for Electromotive Tec3r

What do you think about this BM2LC120FJ-C for re[…]

Still can't find what you're looking for?