Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
User avatar
By FilipW
#7408
Selling three front panel boards (rev 3) for speeduino v0.4.
Link to ebay listing.

The board will fit the plastic frame of a hammond 1455 ver2 box.
Dimensions 103x53x1.6mm
Cutout for three DB15 connectors.
14.5mm hole intended for a bulkhead pressure connector.
2 pads with 5.08mm spacing for a screwable terminal block.
Cutout for a panel mount USB-B connector.

Follow the link to my thread to read more about the front panel.
Attachments
rev3_PCB.jpg
rev3_PCB.jpg (85.64 KiB) Viewed 1370 times

STM32 as well i believe. Is there a reason you wa[…]

In my case the clamp is behind the fuse so the[…]

Good afternoon, test the vvt map leaving off "[…]

Decoders - What do you want to see?

It is completely possible to just do it though. […]

Still can't find what you're looking for?