Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
By bugster_de
#39762
Hi,

I'm working on my own Speeduino board design at the moment (slow progress a long the lines of spare time unfortunately) and I seem to be unable to source the surge protection Varistor in the 5V Powersupply over here in Germany.

The component in question is ERZV14D220.

Can anyone recommend an alternative / replacement for this which would be easier to source?

Thank you so much
By dazq
#39765
Does this mouser part not appear on the German site?

https://www.mouser.co.uk/ProductDetail/ ... oswqDhA%3D
Last edited by dazq on Tue Dec 10, 2019 2:35 pm, edited 1 time in total.
By pazi88
#39766
Any surge varistor with same specs or close enough is same. In mouser/digikey, you can tick the specs of the component and use "show similar" for that.
By dazq
#39768
Sorry pasted wrong link ,changed to correct one now these show delivery expected 16dec, 960 on order
By bugster_de
#39950
Hi folks,

thanks for the reply and hints.
The component shows up on mouser.de but they expect minimum order volume. So I will need to collect my complete BOM and then order with them.

Best regards

Hi all, I'm Fred from France This is my first boar[…]

I have a 0.04.4c board, engine was running well (s[…]

With your gearbox. You have said you are only usi[…]

Volvo 940 Turbo

Hi All, Thought I'd start a thread on my Volvo pr[…]

Still can't find what you're looking for?