For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
User avatar
By JosephHedden
#20521
nioisymime, I picked up some of the free bad v0.3.2 boards some time ago and I am just now finally getting to building them. When I opened the envelope I noticed there are two different colored boards one is red and one is green. The red one is much thicker than the green board is there any difference in them? do they both still not have the grounds connected? TIA
By noisymime
#20569
JosephHedden wrote:
Tue Aug 08, 2017 3:11 pm
nioisymime, I picked up some of the free bad v0.3.2 boards some time ago and I am just now finally getting to building them. When I opened the envelope I noticed there are two different colored boards one is red and one is green. The red one is much thicker than the green board is there any difference in them? do they both still not have the grounds connected? TIA
Were these the ones from me? Honestly, my memory has completely faded about what I wouldn't sent out :D

Can you pop up a couple of pictures? The easiest way is probably going to be to check with a multimeter to see which ground pins are attached.
User avatar
By JosephHedden
#24354
Here are the red boards.
Attachments
20171218_090605.jpg
20171218_090605.jpg (319.22 KiB) Viewed 2228 times
20171218_090536.jpg
20171218_090536.jpg (272.24 KiB) Viewed 2228 times
User avatar
By JosephHedden
#24355
Here are the green boards.
Attachments
20171218_095508.jpg
20171218_095508.jpg (244.98 KiB) Viewed 2228 times
20171218_095540.jpg
20171218_095540.jpg (324.69 KiB) Viewed 2228 times
Problems with noisy tps

there is a software filter setting - under tools-&[…]

Thank you dazq and PSIG, very helpful comments. I[…]

hints & kinks

the speeduino board wasn't going to get me t[…]

Problems loosing sync

Note that some VR conditioner circuits and chips d[…]

Still can't find what you're looking for?