Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
By wygekas
#31562
Hi, im building speeduino board and was wondering if i can swap BOM with electrolytic capcatior because it is hard to get tantalum one. uf rating does match but voltage rating is almost twice larger than one in BOMs.

As well i wanted to ask is it wrong if i replace diodes? i have 1n4004 and instead i would install 1n4007? would that be okay?
#31564
The voltage rating isn't too much of a problem but the capacitor on the output of the regulator must have the correct ESR rating, that is given in the datasheet.
1N4004 is OK, its a 400V diode rather than a 1000V diode and is more than adequate.
Problem with fuel pump outlet

Hello again. I think I found the problem, it is t[…]

Here are wiring diagrams for three Ch(203 or 209) […]

Ok, you can't bypass the 5v regulator, it must hav[…]

Modified 3 cylinder

You should read up on how OEM go about shutting do[…]

Still can't find what you're looking for?