they will be tested and come with a printed enclosure and mounting clip, connectors and pins to make your own wiring harness, Printout of the connections.
These will be $220 AUD plus postage, Ill be donating $20 from every board to Josh Stewart for his great work on the Speeduino firmware.
8 Injector channels
8 Ignition channels/ Switchable 5-12 volt output
4 Low current outputs ULN2803 (paired for 1A) fuel pump, Tachometer output, Thermo fan, Spare
MAP, TPS, O2, CLT, IAT inputs.
Stepper idle control
Buck power supply
5V Sensor inputs
Plug in VR modules, can be used with 5v hall effect without any other circuit and both VR inputs are protected.
Be aware that the current firmware will not run sequential injection and ignition on 6 or 8 cylinders. I run one of these on my V8 using paired injectors and wasted spark. the paired injectors are using 4 injection channels with 0,90,180,270 degrees setting. These will of corse run 4 cylinders with and have 4 high current outputs for Extras/Accessories and you would be able to use the 4 extra ignition outputs also.
Send me a PM if interested.