Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
By stum
Hi All,

Not sure if this is the correct place. but hopefully someone can shed some wisdom on this.

I am trying to diagnose a VR trigger issue, I'm currently running duel wheel, with two pickups. The crank signal is clean and as I would expect. but I am not able to over lay the cam signal. And I can not find out how to add this to the data capture/trace. If I could do this Im sure it would show my problem.

See below I have the Crank signal and it looks good to me. 24 pulses (cam wheel) you can see the compression strokes every 4 pulses, and the slight speed changes.
Now only to see the Cam (reset/sync pulses)

Im using a registered version of TS.

Thanks in advance

Add description
20180124_173737.jpg (3.95 MiB) Viewed 2507 times

You can run your 2JZ in wasted spark and semi sequ[…]

Hi all, I'm Fred from France This is my first boar[…]

I have a 0.04.4c board, engine was running well (s[…]

Volvo 940 Turbo

Hi All, Thought I'd start a thread on my Volvo pr[…]

Still can't find what you're looking for?