Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
By stum
#23835
Hi All,

Not sure if this is the correct place. but hopefully someone can shed some wisdom on this.

I am trying to diagnose a VR trigger issue, I'm currently running duel wheel, with two pickups. The crank signal is clean and as I would expect. but I am not able to over lay the cam signal. And I can not find out how to add this to the data capture/trace. If I could do this Im sure it would show my problem.

See below I have the Crank signal and it looks good to me. 24 pulses (cam wheel) you can see the compression strokes every 4 pulses, and the slight speed changes.
download/file.php?mode=view&id=2844
Now only to see the Cam (reset/sync pulses)

Im using a registered version of TS.

Thanks in advance

StuM
Attachments
20180124_173737.jpg
Add description
20180124_173737.jpg (3.95 MiB) Viewed 2506 times

Hi all, I'm Fred from France This is my first boar[…]

I have a 0.04.4c board, engine was running well (s[…]

With your gearbox. You have said you are only usi[…]

Volvo 940 Turbo

Hi All, Thought I'd start a thread on my Volvo pr[…]

Still can't find what you're looking for?