For any discussion not specifically related to your project
By DannyP
#48744
I had asked over on my build thread(Another Type1 Beetle Motor).

How do we get Tunerstudio to control the Aux outputs? I want to use 3 of them(there are 4) to trigger sequential shift lights. How do I get the lights to come on at say 5900, 6100, and 6300. Rev cut is at 6500.

I have it all wired, they are LED and have a common 12v feed. I know the Aux outputs are a ground trigger so the wiring part is all set. I just need to know how to control this.

I used to have Megajolt and the user outputs are built-in to the GUI.

3 RPM inputs for 3 separate outputs. It should be easy but it's not apparent to me.
By theonewithin
#48751
Programmable outputs.

Under settings at the bottom.

Not in the wiki yet. I'm still trying to wrap my head around how to write it all out along with including board default stuff.
By DannyP
#49327
I haven't been able to find "programmable outputs". I have the following under settings:

Engine constants
Injector characteristics
Trigger setup
IAT density
Baro correction
Reset control
Gauge limits
I/O summary
Attachments
Screenshot (11).png
Screenshot (11).png (521.34 KiB) Viewed 3113 times
Last edited by DannyP on Fri Mar 26, 2021 12:27 pm, edited 1 time in total.
By DannyP
#49329
Speeduino or Tunerstudio?

Speeduino is 202005, Tunerstudio is v3.1.05

I see there have been three updates. Thanks, I'll update the firmware, sorry for the cluelessness over here LOL!
By LPG2CV
#49332
Save your tune first

try a straight upgrade

if you have issues, then best start with a new clear 202103 tune and import the 3 main table and set the rest of the config by hand.

you may need an eeprom clear if you still have issues. :)
By DannyP
#49336
I didn't start the car but everything appears to have updated correctly. I unplugged my Bluetooth board and upgraded with Speedyloader on USB direct. There were a couple mismatches but no problem to fix.

I ALWAYS save my tune on my laptop, just about every day lately LOL!

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?