Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
I should be able to figure this out but learning new stuff for a new job has me mentally taxed. What I wanted to do is update the firmware on my mege2560 with the 16u chip so I can use the no reset while running option. I will running a pi dash hook up directly to the usb on teh speeduino so do not want any resets while running if I have any issues with the raspberry pi.
I have the dfu-programmer files downloaded but can not find the firmware file to upload.
I understand that this should be run from the cmd prompt but must be confusing the process.
Is there any chance there is a how to for this as I think I am making this far harder than it needs to be.
Problem with fuel pump outlet

Did you mean pin 37! Thats pwm idle. If you int[…]

Dyno mode

Thats how it worked wen i worked with it in the OE[…]

LED's 5,6,7,8 on all the time

You need to calibrate the sensors. Else how with […]

Modified 3 cylinder

You could reassign the pins to unused pins.

Still can't find what you're looking for?