Help with building your Speeduino, installing it, getting it to run etc.
User avatar
By Maky1980
#45971
Hello When the engine is at 0 rev the fuel pump relay stays on and off continuously, when I rev it sometimes it stays on and sometimes it stays on and off but at a higher speed. Any idea what can happen? Thanks for your help.
User avatar
By Maky1980
#45985
LPG2CV wrote: Tue Oct 20, 2020 6:48 pm What board, and what have got connected to what? :)
Hi.

first of all thanks for your help.

-the board is a v0.4.3c

-A positive current has been connected to position 1 of the relay actuator, position 2 of the relay actuator to speeduino pin 37 (it has been set in the accessories tab of arduino pin5).

- 3.3v current was connected to another connector of the relay and its corresponding output to a led, and from this to the negative of the source.

attached a video:

https://drive.google.com/file/d/1C6ePPy ... p=drivesdk

thank you very much again
By LPG2CV
#45987
Did you mean pin 37! Thats pwm idle.

If you intended the vvt pin, its 38, and pin 4 in accessories.

Also change vvt to pin 45, to ensure there is no conflict.
User avatar
By Maky1980
#46005
LPG2CV wrote: Wed Oct 21, 2020 3:34 pm Did you mean pin 37! Thats pwm idle.

If you intended the vvt pin, its 38, and pin 4 in accessories.

Also change vvt to pin 45, to ensure there is no conflict.
Hello again.

I did what he told me and the result is practically the same, now it blinks if there is no rev but when there is rev it turns on fixed as it should.

attached video:

https://drive.google.com/file/d/1Ca40RW ... p=drivesdk

thank you very much again.
User avatar
By Maky1980
#46027
Hello again.

I think I found the problem, it is the speedsim himself that is doing some strange things, I tested the signal directly with the car engine and everything is correct.

Thank you very much for your help.

I think possible reasons for that would be: 1) loo[…]

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?