Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Help with building your Speeduino, installing it, getting it to run etc.
#43577
The Hyduino
Hyduino (Speeduino+ H2 Gms ( Gas Management System)

Today We open the Thread
Hydrogen Hot Rod Forum
https://www.hot-rod-usa.com/…/hydroge…/ ... cu-ems-gms

Github
https://github.com/users/SecureSupplies/projects/1

Slack
https://join.slack.com/…/shared_invite/ ... z-L~~_YKUA

https://open-source-energy.org/?topic=3550.new#new
Here and also

Danel Donatelli
Hydrogen Hot Rods

Image
User avatar
By securesupplies
#43612
On Thu, 11 Jun 2020 at 21:21, Chris Cashion chrisv wrote:
Speeduino's boost or vvt outputs could be programmed for tps/manifold air pressure load to drive your HHO setup. The vvt or boost control outputs work by taking the engine speed and load, and converting it to an on/off or PWM output
YES GREAT

so we could avoid this board and just use sensor direct to Hydruino
Image

Image
Attachments
Stanley A Meyer Gas Feed Back Circuit Version 1 V1111dddfdd.png
Stanley A Meyer Gas Feed Back Circuit Version 1 V1111dddfdd.png (118.83 KiB) Viewed 600 times
(120.87 KiB) Downloaded 34 times
(191.49 KiB) Downloaded 34 times
(223.53 KiB) Downloaded 34 times
(9.79 KiB) Downloaded 34 times
#43613
Be reminded how a vacuum advance distributor works.......

by just using the pressure drop at the intake manifold it automatically advances the timing to match load and engine speeds.

The basic idea being you can take a simple signal DIRECTLY from some physical state of the engine at that time and AUTOMATICALLY adjust (in this case pulse with and duration) on the fly
BY ITSELF by just feeding that signal through a simple algorithm. it is smae as taking a cell pressuree signal into
to the Hyduino to calculate the out come.
#44941
Some cool things which could be in

Very handy tools Features
1. Remote engine start in trigger switch
( allpw delayed starts, example would be waiting fuel rail to hit pressure)
2. Fuel fail pressure 0 to 6 bar auto start/delay until rail hits pressure
3. over speed safety cut out / %taco out
4. remote fuel ignition map switch (switch between both maps same time with remote switch button)

Air flows
1 air gate butterfly 100% close or % open control not linked to tps independent settings /pin ,screen or gauge out to show what it is sat at
2 egr recycle 100% close or % open control not linked to tps independent settings /pin ,screen or gauge out to show what it is sat at
(these allow fixed controls independent of tps adjustments)


===================================

LOVE THESE !!!! Great work
Dual ignition map
Dual Fuel Map
Thanks for your great efforts on videos it is very helpful for everyone

I use that on our Speduino powered race car. So fa[…]

When sparkplug is in, starter needs a lot of curre[…]

Saving the code after adjustments

Thank you, Yes the tune.

76 Triumph TR6 to TBI

Sensor has its own heater. 2" seems to me to […]

Still can't find what you're looking for?