Page 1 of 1

Tuner Studio installation

PostPosted:Fri Jul 10, 2020 6:40 pm
by master_pgl
Hi, I am using Raspberry PI 3 as a PC for tunerstudio.
The installation manual says to install libusb before installing speedyloader.

But where to get the libusb-0.1-4:i386 from?

Peter

Re: Tuner Studio installation

PostPosted:Fri Jul 10, 2020 10:11 pm
by Eric H
The :i386 portion if the library specifies the i386 architecture which you are not running.
Use whatever package manager your install in the rpi has to install the newest libusb.
Are you using raspbian or a debian derived system?
if so, "sudo apt-get install libusb" should work.

Re: Tuner Studio installation

PostPosted:Sat Jul 11, 2020 9:05 am
by master_pgl
I set this comand:
Code: Select all
sudo apt-get install libusb
but the answer is libusb not found.

I am using raspbian and have almost no idea about Linux, I can send commands but dont understand what they do.
SO I copied your line - thats it. I think I need the fline libusb at first, or should I change the folder to fire this command?

Re: Tuner Studio installation

PostPosted:Sat Jul 11, 2020 3:58 pm
by Eric H
OK, run this command and see which libusb is available.
apt-cache search 'libusb'

You might need to specify the version of libusb.
On this computer I get a bunch of non-matches plus
libusb-0.1-4 - userspace USB programming library
libusb-1.0-0 - userspace USB programming library
libusb-1.0-0-dev - userspace USB programming library development files
libusb-1.0-doc - documentation for userspace USB programming
libusb-dev - userspace USB programming library development files

I would have to run
sudo apt-get install libusb-1.0.0

Re: Tuner Studio installation

PostPosted:Sun Jul 12, 2020 10:44 am
by noisymime
Assuming you downloaded SpeedyLoader from the usual downloads page (https://speeduino.com/home/support/downloads) the instructions are right there on that page:
On Raspian these should be installed by default, but if not run the cmd:
Code: Select all
sudo apt-get install libusb-1.0-0 libusb-0.1-4

Re: Tuner Studio installation

PostPosted:Tue Jul 14, 2020 6:03 am
by master_pgl
I got it, the driver was already installed, the arduino bord was destroyed. I changed the board and it works.