Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any questions you have before you begin buying, building and installing.
#43395
Greetings all,
I'm new to this and would like some advice. I have a 4EFTE engine in my Tercel which is the one from the Glanza V, I've being wanting to install a standalone ECU however due to some budget issues haven't been able to.

I found this page and it seems pretty good however I have some questions.

What would be the best board for my setup?
Will this work with a 24-1 cam wheel? I plan on running the stock setup for a good while (don't want COP)
Will this work as a full standalone?

Thank you very much.
Problem with fuel pump outlet

Did you mean pin 37! Thats pwm idle. If you int[…]

Dyno mode

Thats how it worked wen i worked with it in the OE[…]

LED's 5,6,7,8 on all the time

You need to calibrate the sensors. Else how with […]

Modified 3 cylinder

You could reassign the pins to unused pins.

Still can't find what you're looking for?