[zoidberg]

Hi there,
i just soldered my speeduino kit and it works like a charm except ignition channel 2
first i thought i fucked something up but debugging i found out that ignition channel 2 on the arduino never goes high.
which sucks a bit because i just need 2 channels for wasted spark but as the ignition channels cannot be reconfigured...

[LPG2CV]

Have you configured TS for the correct board?

[zoidberg]

configured it for 0.4 i think i had it configured for no2c which resultet in it not working at all but now its 0.4
Should i create a new project and try it again?

[LPG2CV]

You don't need a new project, just the correct board selected.
Did it solve it?

[zoidberg]

no didn't help
was on speeduino 0.4 already. i even reflashed it with the last 2019 firmware but that didn't help either.
i suspect that that is an arduino problem not a speeduino one.
Sadly it seems impossible to remap the ignition outputs.
As only need 2.

[LPG2CV]

Now I'm confused!
What board do you physically have?

[zoidberg]

Arduino board?
sunfounder arduino mega clone.

[LPG2CV]

Speeduino board!

[zoidberg]

speeduino 0.4.3.c
says tapr 1.0 and josh steward on the silkscreen

I just flashed a generic blink test programm and pin 38 and 40 are working.
with speeduino on the other hand and hardware testing through tuner studio 38 is not working.

[LPG2CV]

So probably down to a soldering issue then.