New wiki and manual has launched! Check it out at http://wiki.speeduino.com
Any questions you have before you begin buying, building and installing.
#40684
Oh, thank you so much!
Now i understand how it works...

How do you think, it 12-3 enough for good work 2 bores, 2 injectors and ignition timing? Or i should think to increase quantity of tooth?

Thanks!

p.s. Will Speeduino work with 12-3 ? I can setup 12-3 but a don't know will it work ...
#40695
Bear wrote:
Sat Feb 01, 2020 9:43 pm
p.s. Will Speeduino work with 12-3 ? I can setup 12-3 but a don't know will it work ...
I've never specifically tried that combination, but it should work. Theoretically any number of missing teeth up to 50% of the total number will work (Eg a 12-6 would be the biggest gap that would work with the Speeduino code).
Ford Sierra 2.8 V6

What board have you got? Or getting? You can incre[…]

VW 2.0 ABF 16V

So it was time to get the engine back in where it […]

Use MAP acceleration enrichment instead of TPS […]

I realise this post is a year old but....did you […]

Still can't find what you're looking for?