New wiki and manual has launched! Check it out at http://wiki.speeduino.com
Any questions you have before you begin buying, building and installing.
By ManuelR
#40492
Hi everyone,

My name is Manuel and I'm for a lack of a better word a Volvo enthusiast and general petrolhead :D. On top of that I've been descovering arduino and other related electroncis mostly due to Escape Rooms/Games (built a few using mainly arduinos).

Now that said, on the Volvo side I have 1 car that I would like to run on the speeduinom mainly because the wiring is old, it has been "abused" in the past and honestly I don't want to be dependent on a remote tuner.

I have a S60 Challenge (T5) racecar (ex-works). My plan is to get rid of everything that's in there and just have the speeduino controlling things and info on Realdash.

Now, I've read now and again that it works with 5 Cyl engines. Is this correct?

The car has a t5 2.3L turbo engine, with exhaust VVT and drive-by-wire. Can all of this be retained?

The car also has an innovate wideband o2 sensor and that's it (no abs or other creature comforts, after all it's a race car).

Thank you for your inputs!
By dazq
#40493
Hi, welcome.
Firstly please read the wiki top to bottom as that will answer most of your questions. Also searching on here will highlight the remaining issues too.
But
Yes to vvt as long as it is open loop.
No to drive by wire,you need an external controller if you want to keep that
Yes there is 5 cyl support.
Ford Sierra 2.8 V6

What board have you got? Or getting? You can incre[…]

VW 2.0 ABF 16V

So it was time to get the engine back in where it […]

Use MAP acceleration enrichment instead of TPS […]

I realise this post is a year old but....did you […]

Still can't find what you're looking for?