New wiki and manual has launched! Check it out at http://wiki.speeduino.com
Any questions you have before you begin buying, building and installing.
#38815
Ok, so I am about to jump into this... I have a Mitsubishi Mighty Max Pickup that is going to be my test bed. The truck has a N/A SOHC 2.4l 8v 4G64 in it. I would like to swap over to the speedduino and get everything running on the stock motor. Then I am going to install a turbo on the motor.

1. I will be adding a knock sensor to the engine as it currently does not have one.. As I have a clean slate here are there any known issues with the DSM 2G knock sensor as it is the more sensitive than the 1G sensor I would like to run the 2G knock sensor...

2. Does any one have a stock tune on file that I can start with for a Mitsubishi 4 banger G64B, 4G61, 4G63, or 4G64?
#38827
Can't monitor knock as stated. It's not very important either really. Tune the engine correctly and knock isn't an issue


There is a base tune available with the firmware. Use it to build your tune.

Speeduino is DIY. There are no "base tunes" for any particular engine due to being NO standard setup.

Everyone integrates and uses Speeduino differently.

Best to start with the supplied base tune and modifying each menu/tab/option to match your setup and requirements.
Ford Sierra 2.8 V6

Why use the dizzy and TFi? Would be easy to fit a […]

As ric355 says Its the number of write cyles that[…]

Purpose of cap C16 on v0.4.3c?

I had a board laying around so i desolderd cap16 […]

Hi all! I have a 1989 NA6 Mazda MX5, a Speeduino […]

Still can't find what you're looking for?