- Sat Feb 27, 2021 9:00 am
#48640
As above really , I have the 0.4.3 board built up and working and started the install in the car 1.6 4age,
Engine is running R6 ITBs and VW coil pack, things are progressing.
TPS CLT all hooked up and correct data.
36-1 trigger wheel on crank with VR and I have a nice signal and timed up using the fixed timing etc... so the trigger angle is all correct and firing the coil pack (wasted spark) and even runs a bit when you some fuel down its throat so all good so far.
Now the questions is regarding the injection side. The injectors are high Z (11.2 ohms) Ideally I would like to run without a cam sensor, so is the only option to run the injectors paired? or can I run semi sequential with crank only trigger?
and in Tuner Studio I have the Trigger Settings as missing tooth but at the bottom of the settings it wants the secondary trigger settings which dont have. so is it case of I need to run a cam trigger and if so at what point before TDC on number 1 is the trigger needed.
Engine is running R6 ITBs and VW coil pack, things are progressing.
TPS CLT all hooked up and correct data.
36-1 trigger wheel on crank with VR and I have a nice signal and timed up using the fixed timing etc... so the trigger angle is all correct and firing the coil pack (wasted spark) and even runs a bit when you some fuel down its throat so all good so far.
Now the questions is regarding the injection side. The injectors are high Z (11.2 ohms) Ideally I would like to run without a cam sensor, so is the only option to run the injectors paired? or can I run semi sequential with crank only trigger?
and in Tuner Studio I have the Trigger Settings as missing tooth but at the bottom of the settings it wants the secondary trigger settings which dont have. so is it case of I need to run a cam trigger and if so at what point before TDC on number 1 is the trigger needed.
Attachments
tstrigger.jpg (80.2 KiB) Viewed 3810 times