Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any questions you have before you begin buying, building and installing.
#45370
Hello. I want to make fuel injection conversion instead of carbs on Suzuki bandit 1200. I want to assembly board only for injection without ignition parts. I found v0.4.3 board excel parts. Is it the right part list?



P.S. I already assembled one board but with excel from PAZI88 github so thats why I am asking maybe a stupid question.
Attachments
(25.39 KiB) Downloaded 19 times
#45895
Oh sorry it is 1996 Suzuki GSF1200 (detuned version of GSXR1100) i would like to go full speeduino with ignition also because ignition seems to be working as distributor. Also i need to design my trigger wheel and what would be best 12/24/32-1? My designed 24-1 have tooth gap roughly 3,5mm, tooth width 3mm and. With missing tooth the gap is almost 10mm this should be fine right? I add attachments of ignition coil if someone would be kind to help with powering those set ignition coils. What IGBT should i use? (first firing 1 and 4 the other one firing 2,3).
Attachments
20201016_145208.jpg
Ignition coil
20201016_145208.jpg (1.96 MiB) Viewed 104 times

Hi Fellows, Small adjustments into the final desi[…]

Take a look at this: https://speeduino.com/forum/[…]

There is information on driving high voltage injec[…]

Ok, I got the car back together and have been test[…]

Still can't find what you're looking for?