I'd like to replace my Greddy emanage blue with a speeduino 0.4 and an interface board, with keeping my current engine loom.
It would be very helpful if someone could help me while I prepare this project. I'd like to know if I could reuse all the sensors in the engine, informations about the decoders (I think it has one on the crank and one on the intake cam, so sequential mode is possible, please correct me if I'm wrong).
Any advice is welcome!
Thank you in advance,
If I'm right, then the camshaft has a 4-1 teeth pattern and the crank has a 36-2, it's part number is 19315-22020.
I just realised that these are inductive sensors, so I'll have to add a dual VR conditioner.