[dazq]

Hi Darren,

If you need help/support for PCB design for this project, feel free to ask.
Same as you, it's full free service/support .

(Could be nice to use aluminium substrat for some parts if you need a thermal heatsink)

Franck

Thanks for the offer I may take you up on that
At the moment I am testing three driver stages so as to offer the end user best flexibility, these range from relay modules with current sense modules, to generic drivers with various onboard features , finally some ASIC drivers designed with specific control solutions in mind.
In the same way I did with gpio I am trying to leave the hardware very open /abstracted whilst the firmware and config ide remains constant.

[linkus]

This might be the best thing since sliced bread!

[NY:17]

Just came across this thread and had a suggestion/questions

Any other parameters that might be needed ?
Your thoughts please.

Can we add option to shut down non critical circuits if the voltage drops below a certain point?
It would act as limp mode reducing load on battery in case of Alternator failure

Also can we add PWM control(fan speed or water injection pump) based on 2D tables with Analog input or value from speeduino?