Page 1 of 1

Deleting inputs/outputs - what to do on software/firmware side of things?

PostPosted:Fri Jul 31, 2020 1:26 pm
by Wisconsinite762
Hi all,

I'm looking to create a single cylinder fuel only board. With those requirements I can delete quite a bit of the inputs outputs from an existing board design, but when doing that what changes on the software/firmware side of things? Does anything even need to be changed, or do I just ignore the tunerstudio options for things I will no longer have?

Thanks for your input!

Re: Deleting inputs/outputs - what to do on software/firmware side of things?

PostPosted:Fri Jul 31, 2020 3:10 pm
by LPG2CV
The firmwaee will be unaffected.
It will still raise or lower a pin on the mega, however, if you dont have anything connected to that pin, then nothing will happen. :)

Re: Deleting inputs/outputs - what to do on software/firmware side of things?

PostPosted:Fri Jul 31, 2020 4:15 pm
by Wisconsinite762
Great! Good to know, thank you!