Page 2 of 2

Re: My Pro-Spurt+ Module

PostPosted:Sat Aug 01, 2020 3:41 pm
by joey120373
Birdickjp, it is pin compatible with the micro-squirt module, so it should plug in just fine.
However it is pretty much completely untested at this point.

I would like to at least test it on an engine before I release anything. Drop me a PM if you are really interested, I can send a spare PCB If you want to play with one.

Re: My Pro-Spurt+ Module

PostPosted:Mon Aug 03, 2020 4:02 am
by burdickjp
I cannot send PMs but I am interested in testing your board. I have a DIYPNP that I could drop it in.

Email me?
burdickjp@protonmail.com