Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For discussion of Speeduino compatible boards designed / built by other members of the forum and for guidance around making such a board
By malgrips
#40593
Hi I'm seeing nothing in the tooth logger at all.

I have changed the Crank sensor and still the same result.

I will start looking at the Standard E30 wiring

Regards

M
By malgrips
#40595
Hi

I'm a bit of a novice at all this. A bit more background. I bought the ecu ready to go on the standard E30 loom with the standard ignition, injection and trigger hardware on the car.

I did initially start and run. I installed a Wideband O2 sensor so that I could use auto tune with Tuner studio to improve the setup as base map was very rich.

unfortunately I did something and wasn't paying attention and even restoring to an earlier point I still cannot restart the car.

Fuel pump primes, engine cranks, I even appear to have a spark but will not start. Maybe I have damaged something?

Where is VR conditioner please?

Regards

Malcolm
By malgrips
#40652
See attached.
Attachments
25F6BEFD-5F8C-4A81-9CBD-E9472592B298.jpeg
25F6BEFD-5F8C-4A81-9CBD-E9472592B298.jpeg (2.73 MiB) Viewed 1616 times
4CEA5172-83A4-4476-BEF3-1F609C515BA8.jpeg
4CEA5172-83A4-4476-BEF3-1F609C515BA8.jpeg (1.72 MiB) Viewed 1616 times
B175798D-58DA-4A46-A2F7-50C97F1BFAC1.jpeg
B175798D-58DA-4A46-A2F7-50C97F1BFAC1.jpeg (1.76 MiB) Viewed 1616 times
7231D322-C0BC-4BD7-871F-25BE6B6A4BE2.jpeg
7231D322-C0BC-4BD7-871F-25BE6B6A4BE2.jpeg (1.56 MiB) Viewed 1616 times
FCF18A49-4A89-4E62-854E-5F70026412C5.jpeg
FCF18A49-4A89-4E62-854E-5F70026412C5.jpeg (1.57 MiB) Viewed 1616 times
  • 1
  • 11
  • 12
  • 13
  • 14
  • 15
  • 17
Modified 3 cylinder

You could reassign the pins to unused pins.

just re eead ... Download the zip from github. ba[…]

have you calibrated the temp sensors?

You can delete the maf d speedy doesn't need it. Y[…]

Still can't find what you're looking for?