- Tue Nov 10, 2020 9:12 pm
#46366
Hi Fellows
Inspired by the pionners into this part of the forum, i started a new design of stimulator board.
The goal of this design is to include a lot of features to test and stimulate a Speeduino board, but it could be populate according to your need only. Even, with the full populate board (with all the features) final price need to be under control!
(I don't care about the final PCB size, because this PCB will be a Lab. tool. No need to go as small as possible, this tool need to be nice, easy to use and reliable)
Main features:
-8 INJ LED
-8 IGN LED
-8 more LEDs for: FPMP, IDLE, FAN, BOOST, VVT, AUX1, AUX2, TACHO
-10 sensors and 8 Pots: CAM, CRANK, TPS, CLT, MAT, O2, O2_2, Spare, IMAP, EMAP, FLEX, CLUTCH
-Ardu-Stim included for CRANK and CAM signals (with Pot for RPM)
-Push-in connector (no tool needed to connect), with 3.5mm pitch (could be replace by 3.5mm pitch screw terminals)
-Test points for all the relevant signals (Scope) , and also bars for logic analyser.
I will share the schematic ASAP.
At the moment, missing Push button to activate clutch signal, and other stuffs....
Feel free to comment the preliminary PCB.
EDIT 28/12/2020:
Add schematic, assembly drawings from TOP and BOTTOM view for the final design Rev.1.
Inspired by the pionners into this part of the forum, i started a new design of stimulator board.
The goal of this design is to include a lot of features to test and stimulate a Speeduino board, but it could be populate according to your need only. Even, with the full populate board (with all the features) final price need to be under control!
(I don't care about the final PCB size, because this PCB will be a Lab. tool. No need to go as small as possible, this tool need to be nice, easy to use and reliable)
Main features:
-8 INJ LED
-8 IGN LED
-8 more LEDs for: FPMP, IDLE, FAN, BOOST, VVT, AUX1, AUX2, TACHO
-10 sensors and 8 Pots: CAM, CRANK, TPS, CLT, MAT, O2, O2_2, Spare, IMAP, EMAP, FLEX, CLUTCH
-Ardu-Stim included for CRANK and CAM signals (with Pot for RPM)
-Push-in connector (no tool needed to connect), with 3.5mm pitch (could be replace by 3.5mm pitch screw terminals)
-Test points for all the relevant signals (Scope) , and also bars for logic analyser.
I will share the schematic ASAP.
At the moment, missing Push button to activate clutch signal, and other stuffs....
Feel free to comment the preliminary PCB.
EDIT 28/12/2020:
Add schematic, assembly drawings from TOP and BOTTOM view for the final design Rev.1.
Attachments
(70.5 KiB) Downloaded 458 times
(960.45 KiB) Downloaded 594 times
(792.22 KiB) Downloaded 501 times
(276.49 KiB) Downloaded 493 times
Last edited by fram on Mon Dec 28, 2020 5:15 pm, edited 6 times in total.
GITHUB about my Custom Speeduino ECU: https://github.com/FRAMSPEEDUINO/CUSTOM_SPEEDUINO_ECU
- By PSIG
- By Virgilio Caio
- By Spidii