Page 4 of 4

Re: November 2019 firmware update

Posted: Tue Nov 26, 2019 5:34 am
by noisymime
iLeeeZi wrote: Mon Nov 25, 2019 1:10 pm I have been running 6 cylinder sequential without cam signal like that and it works pretty well and it isn't easily noticeable if it has correct or 360 degrees off sync.
This says a lot about how much people really need (or not) sequential :D

Re: November 2019 firmware update

Posted: Tue Nov 26, 2019 12:51 pm
by iLeeeZi
noisymime wrote: Tue Nov 26, 2019 5:34 am
iLeeeZi wrote: Mon Nov 25, 2019 1:10 pm I have been running 6 cylinder sequential without cam signal like that and it works pretty well and it isn't easily noticeable if it has correct or 360 degrees off sync.
This says a lot about how much people really need (or not) sequential :D
I still see sequential injection as a good upgrade. Coming from semi-sequential to untimed sequential was really noticeable on idle and on overrun. It was not easily noticeable if it was running untimed sequential or real sequential and that might be different for different engines. Having every injector inject separately is the main point for me at this time. In future when I add a cam sensor the goal is to have individual injector close angles for every cylinder, as my engine has different injector to valve distance for each bank and that combined to ethanol and cold weather leads to multiple issues.

Sequential injection might not be needed for everyone but in some cases it really makes a difference.

Re: November 2019 firmware update

Posted: Sat Jan 04, 2020 6:12 pm
by Yoosyn
I've just uploaded it. Idle advance control works perfectly. Idle better than OEM :shock: :shock:
Event average MAP sampling needed a lot of filtering in analog filters settings. Set to 230, oscillations gone and off idle throttle response (with minimal acceleration enrichment) is way better than in cycle average.
Cheers!

Re: November 2019 firmware update

Posted: Thu Mar 26, 2020 10:16 am
by martysport
martysport wrote: Thu Nov 21, 2019 12:41 pm Jumpers are correct.

I tried semi and that got an rpm reading. I will look into doing a composite log but I'm not sure how if I'm getting no reading.
I have reverted back to September firmware for now.

Found the problem, wiring and jumpers were spot on but there was a short between VR2+ and VR2- on the VR board. Seems the issue was with the headers, I removed them , cleaned the board and resolderd the headers and its spot on :mrgreen:
IMG_20200325_172704.jpg
IMG_20200325_172704.jpg (3.15 MiB) Viewed 3788 times