SethMains wrote: ↑Mon Jan 25, 2021 5:29 am
I would like to introduce a delay between idle up and the output. I use idle-up to control my A/C, but it stalls my engine most of the time. This seems like an easy thing to add but I'm no programmer
I think what you need is an output setup to activate your a/c after the idleup pin is active and the rpm has risen by an amount above normal idle, perhaps 100-200rpm?
That way the output will remain off until the engine has had a chance to the increase rpm caused by the idleup input trigger.
It will also mean the AC will be switched off if the rpm drops too low , thus preventing a stall condition.
Quantum Coupe with V04 on Ford 1.4CVH,Quantum 2+2 with Custom V04 on Jaguar 3.0l AJ30 V6
mini GPIO :done More soon
CANbus broadcast interface: done
Simple sd logger :done
External CAN io: Inputs :done
Gearbox controller: working