- Wed Oct 14, 2020 8:58 pm
#45869
Hello,
inspired by other ECU manufacturers, how difficult it would be to add a dyno mode? The aim is to be able to fine tune the cells in steady state on dyno, while transmitting most of the essential informations (RPM, ignition timing, lambda, lambda target, etc.) via CAN to the dyno controller. Also the dyno mode should consist of possibility to make sweeps across predefined range of settings, i.e. timing sweep to find MBT. In this mode, it should ignore the tables and allow the operator to input the requested parameters, as well as extract them from the existing tables.
inspired by other ECU manufacturers, how difficult it would be to add a dyno mode? The aim is to be able to fine tune the cells in steady state on dyno, while transmitting most of the essential informations (RPM, ignition timing, lambda, lambda target, etc.) via CAN to the dyno controller. Also the dyno mode should consist of possibility to make sweeps across predefined range of settings, i.e. timing sweep to find MBT. In this mode, it should ignore the tables and allow the operator to input the requested parameters, as well as extract them from the existing tables.