- Thu Oct 15, 2020 6:17 pm
#45879
Hello ! Im running speeduino on my Bmw m50 turbo (stock vr sensors).
Running it on sequential fine till today, full throttle pull with 1st and 2nd gear till rev limiter, then engine turned off and didnt start.
Doesnt sync on cranking...
On semi sequential all works again so seems like it doesnt get signal from camshaft position sensor.
I check all the wires and they are OK, I also tried with another sensor and the problem still same.
What could cause this ?
I dont have a log from this pull, and there is no any changes in msq from other days while it was working.
Thanks guys !
Running it on sequential fine till today, full throttle pull with 1st and 2nd gear till rev limiter, then engine turned off and didnt start.
Doesnt sync on cranking...
On semi sequential all works again so seems like it doesnt get signal from camshaft position sensor.
I check all the wires and they are OK, I also tried with another sensor and the problem still same.
What could cause this ?
I dont have a log from this pull, and there is no any changes in msq from other days while it was working.
Thanks guys !