Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By Knack
#45407
I was running 202005 and the fuel pump priming worked fine. Now that I have updated to 202008 it only primes the pump for about 0.5 second if at all. But the engine will still start and run just fine. i have tried changing the time to 3, 4 and 6 seconds, with no change.

Anybody else see this?
By theonewithin
#45411
Check through ALL settings.

A lot changed in the latest firmware.

You may need to start fresh and load Speeduino base tune first then load your tune over the top and check everything again.
Modified 3 cylinder

As above. Why do you want to do this? What is it[…]

Problem with fuel pump outlet

You need to attach your tune and log of issue. […]

LED's 5,6,7,8 on all the time

At last the penny dropped... Went into the calibra[…]

Dyno mode

Thats how it worked wen i worked with it in the OE[…]

Still can't find what you're looking for?