Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By runis6
#45395
Hello! So i guess from newest update have some issue with RPM limiters. Is not working Launch Control at all, and is not working Engine Protection RPM. So in the TunerStudio the LaunchHard warning is showing when it needed to be activated but the Arduino is doing nothing. I think some problem is in speeduino.ini file, some mistake or something. I also added video below... Also add the tune file. Thanks!

https://youtu.be/ExXaAjBuqxQ

Reinis!
Attachments
(70.63 KiB) Downloaded 13 times
Saving the code after adjustments

Once I have the initial file loaded and setup in t[…]

76 Triumph TR6 to TBI

I've been trying to decide where to put the O2 sen[…]

Modified 3 cylinder

+1 to the other opinions. Run it as 2-cylinder od[…]

+1, that is a popular coil pack with built-n modul[…]

Still can't find what you're looking for?