Page 1 of 1

NO RPM SIGNAL AFTER UPDATING

PostPosted:Fri Sep 11, 2020 9:10 pm
by Sagal89
Hello guys,
i am runing a 201903 version and all runs great (as far as possible with my tuning knowledge...) but it works well!
After this large year and a half, I tried to update. With 202008 version, engine is not firing up. What I can see is that I'm not reading crank signal (rpm ar 0 while cranking).
My trigger settings are:
Missing tooth 60-2, primary trigger crank speed, crank angle -90, trigger edge RISING, secondary FALLING, single tooth cam and medium filtering. This values are working well with 201903 version...
Also, I have checked all new features and edited values on new tables to give logic values...
I'm nearly sure the problem comes from trigger...
Can anyone help me?

Re: NO RPM SIGNAL AFTER UPDATING

PostPosted:Sat Sep 12, 2020 10:47 pm
by theonewithin
No. No one can help.

As you haven't provided your tune or a log of issue

Re: NO RPM SIGNAL AFTER UPDATING

PostPosted:Tue Sep 15, 2020 7:54 pm
by Sagal89
Ok, you're right...
As soon as i have any free time i will do it.
Tooth logger never worked for me... But i will give you something soon.
Thank you
:?

Re: NO RPM SIGNAL AFTER UPDATING

PostPosted:Tue Sep 15, 2020 11:09 pm
by theonewithin
Also the new firmware has a lot of very large changes.

You ought to go through every single option new and old and make sure it is set to something sane.

This is likely one issue.