Speeduino

Hi,

with the new firmware everytime i start the engine (hot or cold) the rpm goes to 2400 when cold and even to 2800 when hot. it stays at that rpm for like 5 seconds and the goes to normal idle, to make sure its not a mechanical issue it tried the previous firmware and the problem is gone. I have looked at all the start up/idle settings and dont see a difference in settings between both firmwares.

Any ideas?

There's a new setting for "crank to run taper" in idle settings. Change it to 0 seconds and it should be back to normal. I had the same thing when I updated.

ooh!

Rob123456789 wrote: ↑Fri Jun 05, 2020 2:58 pm There's a new setting for "crank to run taper" in idle settings. Change it to 0 seconds and it should be back to normal. I had the same thing when I updated.

I will try it this weekend.

Thanks for the response!

Rob, thanks a lot that fixed it